Certification

SCOPE OF THE PROGRAMME

The Eurovent Certified Performance (ECP) programme scope for Cooling Towers (CT), applies to factory packaged Cooling Tower product series (family) & subgroup ranges (or product lines) of Open & Closed-Circuit series Cooling Towers.

Eurovent Certita Certification (ECC) have a collaborative arrangement with USA based Cooling Technology Institute Est. 1950 (CTI) to use the CTI Thermal Performance Certification STD-201 (latest version) for certification compliance. 

There are three key requirement steps to achieve and maintain ECC certification in compliance to the CTI STD-201.  These being;

1. Qualification Procedure,
2. Repetition Procedure 
3. Factory Audit*.

*Factory auditing is an additional scope item above that of CTI STD-201.  This will be explained further in Section "Factory Audit".

The programme applies to product series & sub-group ranges that:

• Have already achieved and hold current certification by the COOLING TECHNOLOGY INSTITUTE (CTI) according to latest CTI STD-201OM
• Are not in process or certified by CTI before 01/10/2010, manufactured by a company with their cooling tower headquarter or main facility located in the following areas (approved Eurovent Certita Certification areas):
  • Europe
  • Middle East, Africa
  • India.

For more information about the Cooling Technology Institute (CTI), click on the logo for the CTI home page : 

For more information about CTI Cooling Tower Certification, click on the logo for the CTI cooling tower certification programme page : 

CERTIFY-MORE PRINCIPLE

During 2020 the programme committee for cooling towers worked to develop a certify-more principle, with a stepped introduction plan. This principle covers products that are sold into Europe and European markets as specified in the certification manual. 

a) Starting from January 1st 2022, all participants shall certify their main range with the scope of the certification programme, and main option. Any option representing more than 20% of unit quantity within a range shall be required to be part of the certified range. Also any new range released by the participant from January 1st, 2022 within the scope of certification shall declare it to Eurovent Certita Certification for inclusion of the certification process.
b) From January 1st, 2024 50% of all in scope certifiable units must be certified units. 
c) From January 1st, 2026 80% of all in scope certifiable units must be certified units. 

PRODUCT TYPE

Cooling towers, also commonly known as evaporative heat rejection equipment, are a refrigeration system component designed to transfer heat from HVAC systems to the outdoor environment via water and air. Commonly used with chiller systems, cooling towers can be used in both buildings and processes, in a wide range of applications, from large residential to commercial and industrial.

Cooling towers are a specialised heat exchanger, in which air and water are brought into direct contact with each other, in order to reduce the water's temperature. Water heated by an industrial process or air-conditioning condenser, is pumped to the cooling tower through pipes. Once in the cooling tower, water sprays through nozzles onto banks of material called fill, which slows the flow of water through the cooling tower, and exposes as much water surface area as possible for maximum air-water contact. As the water flows through the cooling tower, it is exposed to air, which is pulled through the tower by a fan. When the water and air meet, a small amount of water is evaporated, creating a cooling action. The cooled water is then pumped back to the condenser or industrial process where the cycle starts again.

There are two main types of certified Cooling Tower:

• Open-Circuit
• Closed-Circuit 

These cooling tower types have the same design system purpose. However, closed circuit cooling towers reject heat from the water pipes to the air via a heat exchange coil, isolating the process fluid from the outside air, keeping it clean and contaminate free in a closed loop.

DEFINITIONS

While exploring our certified products you’ll come across a number of technical terms relating to certification. The below definitions help explain the search criteria in our certified product directory.

Certified product types in the CT programme have the following search criteria in common: